From Roofs to Walls and Gutters: Where to Use KVR Liquid Rubber

From Roofs to Walls and Gutters: Where to Use KVR Liquid Rubber

Rainwater can find its way through a leaking gutter joint, run down an exterior wall or seep in around roof flashing. KVR Liquid Rubber is a flexible waterproofing coating for a range of surfaces around your home or job site. Here’s where you can use it and what to check before you start.

Exterior walls and boundary walls

Walls that face wind-driven rain can benefit from a waterproof coating. Use KVR Liquid Rubber on suitable, properly prepared exterior walls, parapets and boundary walls to help reduce rainwater penetration. If you see peeling paint or damp patches after rain, check for cracked plaster, gaps around windows or an overflowing gutter before coating.

Interior walls

KVR Liquid Rubber can be used on suitable interior walls once the source of any damp has been addressed. A damp patch could come from a plumbing leak, rainwater getting in from outside, condensation or moisture rising from the ground. Fix the cause first and let the wall dry completely before applying any coat. A wall can feel dry to the touch while moisture remains in the plaster.

Gutters and flashings

Check gutter seams, corners and joints for drips and look for water stains below the gutter line. Clear blockages and repair damaged sections first. KVR Liquid Rubber can then be used on suitable gutter joints and flashings, including the areas where a roof meets a wall. Ask our team whether your project needs reinforcement at the joints.

Wood and metal

KVR Liquid Rubber can also be used on suitable timber and metal surfaces. For timber, check that it’s sound and dry and remove any loose finish. For metal, clean off dirt, grease and loose rust, then check the preparation and primer requirements for the surface. If you’re coating over an existing finish, ask us about compatibility first.

Roofs and roof repairs

From a local repair to a larger roof project, give extra attention to fasteners, overlaps and edges where water can find its way in. Repair damaged areas and follow the preparation and application instructions for your roof type.

Foundations, dams and ponds

These projects have different waterproofing requirements. Tell us what you’re coating and how the area will be used so we can confirm product suitability, surface preparation and curing requirements before you order.

Ready to waterproof your next project?

KVR Liquid Rubber is available in 5L and 20L and can be applied by brush, roller or suitable spray equipment, depending on the job. Send the KVR Coatings team a photo, your surface type and approximate measurements. We’ll help you work out how much coating you need and what preparation the job calls for.